Cosmos Forum

Cosmoneer Proto => Command & Data Handling (microController) => : Cosmoneer December 01, 2016, 11:24:10 AM

: Command and Control
: Cosmoneer December 01, 2016, 11:24:10 AM
What better way to control your Cosmoneer than with a proven, open source command and control platform that has been used in previous space missions!

Sparkfun wrote a great article on the application, which can be read here:
https://www.sparkfun.com/news/2022 (https://www.sparkfun.com/news/2022)

For further reading and investigation, the project itself is found here:
http://cosmosrb.com/ (http://cosmosrb.com/)
: Re: Command and Control
: digital_gods April 05, 2017, 12:31:18 AM
I found a breif tutorial for configuring COSMOS and Arduino to play together. http://www.williamosman.com/2016/08/cosmos-and-arduino-20-telemetry-system.html?m=1
: Re: Command and Control
: digital_gods April 23, 2017, 11:41:34 PM
I found a breif tutorial for configuring COSMOS and Arduino to play together. http://www.williamosman.com/2016/08/cosmos-and-arduino-20-telemetry-system.html?m=1
I'm trying to get Ball Aerospace Cosmos (http://cosmosrb.com) telemetry software to work on Win10 64-bit without much luck. A couple of the components don't get installed not will the demo load. This week I'm setting up a Win 7 VM to test on. Can someone else see if it will install on their copy of Win 10?

--Robert
: Re: Command and Control
: Cosmoneer May 10, 2017, 03:51:28 AM
Hi Robert,

Did you have any luck getting this installed?  Also, what was the specific error message you received during the installation?



-Cosmoneer